|
Post by ares17 on Dec 5, 2006 14:09:40 GMT 7
Hi all....just got myself a motor to use on my D1. I'm planning to install bearings on it instead of the stock bushing. Can anyone tell me wats the size of the bearings used in 540 size motor? And also how to remove the comms fron the motor to install the bearing? Anything in particular I should take note off apart from the motor timing? thanx all.
|
|
|
Post by ares17 on Dec 7, 2006 7:45:14 GMT 7
Bearings found. But got difficulty in removing the endbell from the motor for the GT tune motor. Anyone got any advice?
|
|
|
Post by AGP™ on Dec 10, 2006 16:58:42 GMT 7
where u got the bearing from? i wanted to change for my tz motor too
|
|
|
Post by ares17 on Dec 10, 2006 18:57:15 GMT 7
From some old race motor i had...size i never measure.
|
|